Water heater not working in Lisbon: esquentador, termoacumulador or boiler?
Free tool: Electric water heater: repair or replace?
No hot water is one of the most common messages we get from people in Lisbon flats. The fix depends entirely on what kind of heater you have, so start there.
Step 1: work out what you have
Gas esquentador (instant gas water heater)
- A white box on the wall, usually in the kitchen or a utility area, with a flue pipe going out through the wall or into a chimney.
- It heats water only while a hot tap is open. You may hear a click and a soft “whoomp” as the flame lights, and see the flame through a small window.
- Ignition is by batteries (often two large D cells in a drawer underneath), by mains electricity (a plug nearby) or by a small turbine powered by the water flow.
- Gas comes from a gas bottle (butane or propane, with a regulator on top) or from the natural gas mains.
Electric termoacumulador (hot water tank)
- A white cylinder, often in a kitchen cupboard, above the bath or on the bathroom wall.
- It heats and stores water, typically 50 to 100 litres, so hot water can run out and then takes a while to come back.
- It has a temperature dial and a small light that shows when it is heating.
Combi boiler (caldeira)
- Looks like a larger esquentador but also feeds radiators or underfloor heating. It usually has a display and a pressure gauge.
Step 2: checks you can do safely
If it is an esquentador
- Batteries. If it clicks but does not light, or lights only sometimes, change the batteries first. This solves more cases than anything else.
- Gas bottle. Is it empty? Lift it: an empty bottle feels light. Check the regulator (the valve on top) is switched on. In cold weather, butane can struggle when the bottle is nearly empty.
- Gas valve. The tap on the gas pipe below the heater is usually open when the handle is in line with the pipe.
- Water flow. An esquentador only lights when enough water flows through it. If one tap gets hot and another does not, or it lights with the tap fully open but cuts out when you turn it down, the flow is too low. Clean the tap aerator (the mesh at the end of the spout) and try with the mixer fully on hot.
- Mains models. Check it is plugged in and the socket works.
If it is a termoacumulador
- Breaker. Look at your electrical board (quadro elétrico) and check whether a breaker has tripped. If it trips again straight away, stop and do not keep resetting it.
- Thermostat dial. Make sure it has not been turned down, and that the light comes on.
- Time. After a long shower or a few baths, the tank may simply be empty. Wait for it to reheat before deciding it is broken.
If it is a boiler
- Check the display for an error code and the pressure gauge. Most combi boilers want roughly 1 to 1.5 bar when cold; if it is much lower, the manual explains how to top it up.
- Check the gas supply and that the boiler is switched on.
Common symptoms and what they usually mean
- Lukewarm water. On a termoacumulador: thermostat, heating element or limescale. Lisbon water is hard, so scale builds up inside the tank over the years. On an esquentador: low flow, settings, or a heat exchanger furred with scale.
- Hot water cuts out after a few minutes or when someone opens another tap. Classic esquentador behaviour when the flow drops below its minimum, or when an overheating or flue safety sensor shuts it off. A sensor that keeps tripping needs a plumber.
- Error code on the display. Codes such as EA, C2 or H.01 mean different things on different brands. On many Vulcano and Bosch esquentadores, EA means the flame was not detected. Take a photo of the code.
- Noises. Rumbling or crackling when heating usually means scale. Whistling can be a partly closed valve or a restriction in the pipe.
- Water under the heater. A drip from the safety valve while heating is normal; water pooling underneath or a wet bottom of the tank is not. Turn the heater off and close its water inlet.
What not to do
- Do not open the casing of a gas heater or try to adjust gas parts.
- Do not keep resetting a breaker that trips again.
- Do not block the flue or the ventilation grille in the room.
If you smell gas
- Close the gas at the bottle regulator or the meter valve.
- Do not touch light switches, appliances or your doorbell, and do not light anything.
- Open the windows.
- Leave the flat and call your gas distributor’s emergency line (on your contract or bill) or 112.
We do not fix gas leaks or work on the gas supply itself: work on the gas installation is done by a certified gas company.
What to send us
On WhatsApp, send:
- A photo of the brand plate (the sticker with brand and model, usually on the side or underneath).
- A photo of any error code.
- A short video of what happens when you open a hot tap.
- Your area and whether it is on gas bottle or mains gas.
Repair or replace?
- Termoacumuladores: we repair Vulcano, Bosch, Baxi and Vaillant units up to about 15 years old, service and descale them, change safety valves and hoses, move them to another wall, and supply and fit new ones (or fit one you bought).
- Esquentadores: we repair Vulcano, Bosch, Junkers and Baxi, and replace units on the existing gas connection. We do not move gas heaters or run new gas lines.
- Boilers: we repair Vulcano, Bosch, Junkers, Baxi and Vaillant; other brands are replaced.
- Low-end brands such as Teka, Ariston and similar are replaced rather than repaired, because parts and reliability rarely justify a repair.
You get a written quote on WhatsApp before any work starts, and a VAT invoice with your NIF (Portuguese tax number). Our team speaks English and Portuguese.
Get help
If the checks above have not brought the hot water back, see our water heaters and boilers page or message us on WhatsApp with the photos. We reply fast and tell you whether it looks like a repair or a replacement.