Which termoacumulador size do you need? A water heater size guide for Portuguese homes
Free tool: Which electric water heater size do I need?
Most flats in Portugal without gas get their hot water from a termoacumulador, an electric hot water tank usually tucked into a kitchen cupboard, above the bath or on the bathroom wall. If you are replacing one, or you have just moved in and the hot water keeps running out halfway through the second shower, the question is the same: which size do you actually need?
How a termoacumulador works
A termoacumulador heats water with an electric element and stores it hot until you use it. That is the key difference from a gas esquentador (instant gas water heater), which heats water only while the tap is open and never runs out as long as there is gas. A tank has a limit: once the hot water is used up, you wait for it to reheat.
So size matters. Too small and the household has to space out showers. Too big and you lose cupboard space, add a lot of weight to the wall and keep water hot that nobody uses.
The short answer: size by household
For normal-length showers:
| Size | Suits | Notes |
|---|---|---|
| 50 L | 1 person, studio or T0 | Showers only, no bath |
| 80 L | 2 to 3 people | The most common size in T1 and T2 flats |
| 100 L | 3 to 4 people | Back-to-back morning showers, an occasional bath |
| 150 L | 4 or more people | Two bathrooms or regular baths |
(T0, T1, T2 is how Portuguese listings describe flats: the number of bedrooms.)
Choosing between 80 and 100 litres
This is where most people hesitate. Go for the larger tank if:
- Showers happen back to back. Two or three people showering one after another in the morning is the classic case where an 80 L tank runs short for the last person.
- You use the bath. Filling a bath takes a large share of an 80 L tank.
- You have a rain shower head. These use far more hot water than a standard head.
- You heat at night. On a two-rate electricity tariff (bi-horário), the tank heats mostly overnight and has to last the next day.
- It also feeds the kitchen sink. Washing up by hand adds to the daily use.
If none of these apply and space is tight, 80 L is usually fine.
Weight, space and the wall
Check these before ordering a bigger tank:
- Weight. A litre of water weighs a kilo, so a full 100 L tank weighs well over 100 kg once you add the tank itself. It needs a solid wall. In older buildings in central Lisbon (Pombaline and gaioleiro buildings from the 18th to the early 20th century), many internal walls are thin lath-and-plaster partitions (tabique) that cannot carry that load without reinforcement.
- Space. Measure the height, width and depth available, and leave room for the safety valve and for servicing. Cupboards built around an old 80 L tank often do not fit a 100 L.
- Vertical or horizontal. Vertical tanks are the most common and heat more efficiently. Horizontal models exist for false ceilings, above doors and low spaces.
- Electrics. The tank needs a suitable dedicated circuit on your electrical board (quadro elétrico), and enough contracted power (potência contratada) for the rest of the home. If the breaker already trips with the old tank, get that looked at before the swap.
Signs your tank is due for replacement
- Water leaking from underneath or a wet bottom of the tank. A drip from the safety valve while heating is normal, because the water expands; the tank itself leaking is not.
- Hot water that comes out brown or smells.
- Water getting less hot over time, even with the thermostat turned up.
- A breaker that trips whenever the tank switches on.
- Repeated faults on a low-end unit.
Not every problem means a new tank. We repair Vulcano, Bosch, Baxi and Vaillant termoacumuladores up to about 15 years old: elements, thermostats, safety valves and hoses, plus a service and descale. Lisbon water is hard, so limescale builds up in the bottom of the tank over the years and reduces the hot water you get. Low-end brands such as Teka, Ariston and similar are replaced rather than repaired, because parts and reliability rarely justify it. If your heater has stopped working altogether, our guide to a water heater not working in Lisbon covers the checks to do first.
What to do right now if it is leaking
- Switch off the breaker for the water heater.
- Close the cold water inlet to the tank (the tap on the pipe going into it).
- Never block or cap the safety valve, even if it drips: it protects the tank from too much pressure.
What to send us
On WhatsApp, send:
- A photo of the brand plate on your current tank (brand, model and capacity).
- A photo of where it is, with the water connections visible.
- How many people live in the home and whether you use the bath.
- Whether you want it in the same place or moved to another wall.
- Your area.
How a replacement goes
We supply and fit new termoacumuladores, or fit one you have bought yourself. We take out the old unit, mount the new one with a new safety valve and connections, fill it, and check for leaks before we leave. We can also move a tank to another wall when the current spot does not work.
You get a written quote on WhatsApp before any work starts, and a VAT invoice with your NIF (Portuguese tax number). Our team speaks English and Portuguese.
Get help choosing
If you are still unsure between sizes, see our water heaters and boilers page or send us the photos on WhatsApp. We reply fast and tell you which size makes sense for your home and whether your wall and cupboard can take it.